Basic Settings

Basic settings

Operating mode for patterns

Select operating mode of the Yarn Length Control.

The following 3 options are available.

Production without YLC

Working without Yarn Length Control.

Working with mm

Determination of correction data.

Production according to the [mm] table (replaces YLC1, 7YLC and YLC8)

Working with Master Piece

Determination of Master Piece data.

Production (replaces YLC5 and YLC 6)

Comment

Enter a comment.

Correction Data

The checkbox is active, if correction data was imported from the machine using the Setup import.
The correction data can not be edited.

Master Piece Data

The checkbox is active, if the Master Piece data was imported from the machine using the Setup import.
The Master Piece data can not be edited.

Measuring Wheels on the Left

Wheel

Identification number of the measuring wheels
Left (9 to 16)

Y

Yarn carrier working with this measuring wheel

YCU

Select the yarn control unit working with the measuring wheel.

< +/- [%]

Correction value < +/- [%] for the yarn length control on the left hand side

Description

Note on the use of the entry. You can enter a text here.

Measuring Wheels on the Right

Wheel

Identification number of the measuring wheels
Right (1 to 8)

Y

Yarn carrier working with this measuring wheel

YCU

Select the yarn control unit working with the measuring wheel.

> +/- [%]

Correction value > +/- [%] for the yarn length control on the right hand side

Description

Note on the use of the entry. You can enter a text here.

Correction

Correction for all measuring wheels

Make correction for all measuring wheels.

Value [%]

Enter the correction value.

Comment

Enter a text.

Maximal deviation from set value per knitting row

Specify the maximum deviation of the target value per knitting row allowed.

Value [%]

Enter value for the allowed deviation.

Comment

Enter a text.

Yarn Correction for Master Piece

Make correction for the original piece (Master Piece).

Value [%]

Enter the correction value.

Comment

Enter a text.

Minimum width for Master Piece

There is a minimum width for working with Master Piece.

Default []

Shows the default minimum width.

Modification [needles]

Enter the change for the minimum width.

Comment

Enter a text.