Clamping

Utilizar pinçamento (no projecto completo)

• If while generating a pattern a machine with a comb is selected and the check box Pente is activated in the process, then the check box Utilizar pinçamento (no projecto completo) is already activated, but is not available.
• If when generating a new pattern the Pente check box was deactivated, then the Utilizar pinçamento (no projecto completo) check box is available.
  As a result, it is possible to work without a comb but with clamping.
• This setting applies to all patterns in the project.
  All knitting programs in the knitting order for the machine need the same yarn carrier home position.

Desativar pinçamento depois de entrar tecendo os guia-fios

Only available if Utilizar pinçamento (no projecto completo) is activated.

All yarn carriers will be taken out of the clamp at the start. Clamping and cutting will be disabled and the yarn carriers will be positioned on the clamping/cutting bed.
The total width of the needle bed can be used for knitting.

Clamping at Fabric End in the Cast-off Function (RS17=0)

Only available if Utilizar pinçamento (no projecto completo) is activated.

• Clamping occurs in the cast-off function.
  With it the comb and the casting-off can be switched off by RS17=1.
• The following pieces will be knit without comb take-down.
• RS17=0 will automatically be set for the last piece in order to get the yarns clamped and the fabric cast-off.
  The setting Instrução de Sintral / PRINT appears for selection.

Instrução de Sintral / PRINT

Only available if Clamping at Fabric End in the Cast-off Function (RS17=0) is activated.

Select a Sintral Instruction / PRINT.
The selection will be applied to the last pattern row.