Plating Offset (YPI)

The Vanize ofseti (YPI) tab only appears for ADF machines.

YPI

Endeks (vanize) D = Sintral'de direkt değer

Yerleştirme pozisyonu <<

Sola gidişte mekik ofseti (-100.0 ilâ +100.0 mm)

Horizontal panning of the insertion position (x)

  • Positive value: Following basic yarn.
    The thread is inserted in the needles later on.
    Default: 6.5 mm
  • Negative value: Leading plating yarn
    Default: 0 mm

Value range: -100.0 to 100.0 mm
Step width: 0.1 mm

Yükseklik <<

Sola gidişte mekik yükseklik ofseti (-2.0 - +5.0 mm)

Panning in height (y)
Corrects the insertion angle

  • Positive value: Steeper yarn angle
    Default: 0.9 mm for the following basic yarn
  • Negative value: Flatter yarn angle

Value range: -2.0 to 5.0 mm
Step width: 0.1 mm

Yerleştirme pozisyonu >>

Sağa gidişte mekik ofseti (-100.0 ilâ +100.0 mm)

Horizontal panning of the insertion position (x)

  • Positive value: Following basic yarn.
    The thread is inserted in the needles later on.
    Default: 6.5 mm
  • Negative value: Leading plating yarn
    Default: 0 mm

Value range: -100.0 to 100.0 mm
Step width: 0.1 mm

Yükseklik >>

Sağa gidişte mekik yükseklik ofseti (-2.0 - +5.0 mm)

Panning in height (y)
Corrects the insertion angle

  • Positive value: Steeper yarn angle
    Default: 0.9 mm for the following basic yarn
  • Negative value: Flatter yarn angle

Value range: -2.0 to 5.0 mm
Step width: 0.1 mm

Açıklama

Girdinin kullanımı ile ilgili bilgi. Buraya bir metin girebilirsiniz.