Presser Feet (Pattern Parameters)
- 1
- Call up Başlat tab -> Parametreler group ->
Pattern Parameters
. - 2
- Select the
Bastırıcı ayak section.
Machines that are equipped with presser feet, are marked with the letter W.
If you want to insert them in the pattern, then proceed as follows:
- Select the presser foot type for every position in the Yapılandırma dialog box, Makine öznitelikleri tab, Bastırıcı ayak section.
Presser Foot - Make the desired setting in the Pattern Parameters , Bastırıcı ayak section.
- The entries of the section are then entered into the pattern using the control columns.
Control Column Group 3
Click on the red-framed areas of the image to access the description directly.
Make the following settings in the Bastırıcı ayak section:
|
1 |
General settings in the upper pane: |
|
2 |
Settings in the table: |
|
3 |
General Columns: |
Further Information