System Functions

系统功能 Section

Set the different available functions for every knitting system on every needle bed.

还原默认

Resets the settings to the default values.

系统功能

Make settings per system, carriage direction and needle bed for the following selection:

集圈

Not Sunken Tuck

线圈

采用分针

沉圈

从针床翻针

分路密度三角

驱动衬垫导纱器

With machines with additional bed appears the selection:
送圈到辅助针床

全选

Enter settings for all systems
< > in both carriage directions
<< >> separated according to carriage direction

Click on the + to set the presentation to separated according to carriage direction.

Click on the - to set the presentation to in both carriage directions.

S1 – Sx

Settings for the respective system
< > in both carriage directions
<< >> separated according to carriage direction

毛圈

Activate the check box, when the plush technique is to be used to knit.

  • Knitting Technique: Plush

毛圈系统

Shows the systems that can work with plush.

系统转换

You have these options for a system conversion depending on the selected machine:

通过集圈功能深度下拉

The selection 集圈 is disabled for the converted systems.

镂空花型（1系统）

  • Devoré Knitting Technique
  • For ADF machines only and only for the rear needle bed
  • System conversion at the machine is necessary.
  • Further settings are necessary in the System Function control column.
  • The following function appears when selecting Devoré:
    • 使用带有镂空（1系统）转换件的系统进行标准编织。
    • Systems with Devoré conversion are not recommended for knitting and therefore also disabled by default.
    • Activate this function if you still want to use the converted system for ordinary knitting.
    • Provide a plating color with YPI for the corresponding areas.

Different system functions are disabled automatically for the converted systems.

FlexPly

The FlexPly knitting technique essentially corresponds to the Devoré technique executed on both needle beds in the same system.

  • FlexPly Knitting Technique
  • FlexPly is available for ADF machines of the EKC type and 7.2.
  • A system conversion at the machine is necessary for both needle beds in the same system to use FlexPly.
  • The FlexPly 前后板 setting is required in the System Function control column.
    System Function
  • The following function appears with FlexPly selected:
    • 使用带有 FlexPly 转换件的系统进行标准编织。
    • It is not recommended to knit in systems with FlexPly conversion and therefore also disabled by default.
    • Activate this function if you still want to use the converted system for ordinary knitting.
    • Provide a plating color with YPI for the corresponding areas.

Systems converted for FlexPly cannot drive yarn carriers into clamping position.

FlexPly 配套件