Presser Feet (Pattern Parameters)
- 1
- Call up 起头 tab -> 参数 group ->
Pattern Parameters
. - 2
- Select the
压脚 section.
Machines that are equipped with presser feet, are marked with the letter W.
If you want to insert them in the pattern, then proceed as follows:
- Select the presser foot type for every position in the 配置 dialog box, 机器属性 tab, 压脚 section.
Presser Foot - Make the desired setting in the Pattern Parameters , 压脚 section.
- The entries of the section are then entered into the pattern using the control columns.
Control Column Group 3
Click on the red-framed areas of the image to access the description directly.
Make the following settings in the 压脚 section:
|
1 |
General settings in the upper pane: |
|
2 |
Settings in the table: |
|
3 |
General Columns: |
Further Information