Usage of Rectangle

Draw with or without attributes

• If you selected cursor attributes, they will be applied to the pattern when drawing.
• If you did not select any cursor attributes, the area will be selected.
  The selected area is available for further editing.

Draw an outlined rectangle

• Select Rectangle Not Filled
• Enter a Line Weight value (e.g. 3).
• Set Offset X and Offset Y to 0 (zero).
• Draw the Rectangle.(e.g. without attributes).
  Width and height of the rectangle appears in the tooltip.

Draw an outlined square by dot line

• Select Rectangle Not Filled
• Set the Line Weight value (e.g. 2).
• Set the value for Offset X (e.g. 1) and Offset Y (e.g. 2).
• Select Square or press the SHIFT key when drawing.
• Draw the Square (with yarn color red e.g.)
  Width and height of the square appears in the tooltip.

Draw a filled rectangle starting from the center

• Select Rectangle Filled
• Set Offset X and Offset Y to 0 (zero).
• Select Start From Center.
  Only odd side lengths are possible.
• Draw the Rectangle (with yarn color red e.g.)
• The first mouse click specifies the center of the rectangle.
  Width and height of the rectangle appears in the tooltip.

Draw by dot line a filled rectangle with modules

• Select Rectangle Filled
• Set the value for Offset X (e.g. 2) and Offset Y (e.g. 1).
• Select a module (e.g. Pointelle, Stitch v)
• Draw the Rectangle.
  Width and height of the rectangle appears in the tooltip.

Draw by dot line a filled rectangle with modules with repetition element

When you select a module with repetition element for filling, observe the following procedure:

• Select Rectangle Filled
• Set the value for Offset X (e.g. 2) and Offset Y (e.g. 1).
• Select a module with repetition element(e.g. Pointelle, Stitch v, above).
• Draw the repeating part defining its size with the first and second mouse click.

• Then, draw the Rectangle with the repeating part and the entered offset.
  Width and height of the rectangle appears in the tooltip.

Draw an outlined rectangle by the echo mode

• Select Rectangle Not Filled
• Enter a Line Weight value (e.g. 1).
• Set Offset X and Offset Y to 0 (zero).
• Select Drawing by Echo Mode.
• Draw the Rectangle (with yarn color red e.g.)
  After the second click, the echo with the handles appears.
  You can change or move it.

• Apply the rectangle to the pattern by ENTER.
  A new rectangle appears with handles for moving and changing.
• You can repeat the procedure as often as desired.