Clamping

Use Clamping (within complete project)

• If while generating a pattern a machine with a comb is selected and the check box Comb is activated in the process, then the check box Use Clamping (within complete project) is already activated, but is not available.
• If when generating a new pattern the Comb check box was deactivated, then the Use Clamping (within complete project) check box is available.
  As a result, it is possible to work without a comb but with clamping.
• This setting applies to all patterns in the project.
  All knitting programs in the knitting order for the machine need the same yarn carrier home position.

Deactivate clamping after knitting-in the yarn carriers

Only available if Use Clamping (within complete project) is activated.

All yarn carriers will be taken out of the clamp at the start. Clamping and cutting will be disabled and the yarn carriers will be positioned on the clamping/cutting bed.
The total width of the needle bed can be used for knitting.

Clamping at Fabric End in the Cast-off Function (RS17=0)

Only available if Use Clamping (within complete project) is activated.

• Clamping occurs in the cast-off function.
  With it the comb and the casting-off can be switched off by RS17=1.
• The following pieces will be knit without comb take-down.
• RS17=0 will automatically be set for the last piece in order to get the yarns clamped and the fabric cast-off.
  The setting Sintral Instruction / PRINT appears for selection.

Sintral Instruction / PRINT

Only available if Clamping at Fabric End in the Cast-off Function (RS17=0) is activated.

Select a Sintral Instruction / PRINT.
The selection will be applied to the last pattern row.