Collecting clamp unit

    1
    Position the yarn carriers next to the corresponding collecting clamp unit on the right or on the left according to the yarn carrier home position.
    2
    Insert the yarn ends manually into the collecting clamp unit.

1

Cutting device

2

Collecting clamp 1

3

Collecting clamp 2

4

Yarn Carriers

The collecting clamp units are mounted on the left and right next to the needle bed. Each one works with two collecting clamps (2), (3) and a cutting device (1).

The collecting clamp unit holds the thread of a yarn carrier not used for knitting at the moment.

If the yarn carrier (4) is not needed anymore, it is positioned outside the collecting clamp unit. The collecting clamp (2) or (3) catches the thread and pulls the thread downward. Then the thread is cut off by the cutting device (1).

When the yarn carrier is used again, the collecting clamp opens after knitting a few rows and the yarn end is released. The number of rows knitted until the clamping device opens up, is programmed in the knitting program.

    1
    Place the yarn carrier (1) outside the collecting clamp unit.
    The yarn carrier may not be positioned above the collecting clamp unit - risk of damage.
    2. 2
    Take the yarn from the yarn carrier and pull it up to the needle bed (2).
    3
    Hold the yarn.
    4
    Open the Intervenir a mano II menu.
    Producir pedido -> Intervenir a mano II
    5
    In the Intervenir a mano II window tap the Pinzado y corte button.
    Intervenir a mano II -> Pinzado y corte
    6
    Tap the button Clamp 1 is Closed or Clamp 2 is Closed.
    Left collecting clamp unit - area (3)
    Right collecting clamp unit - area (4)
  3. The thread is gripped by the collecting clamp and fixed.
    If there is already a thread fixed in the selected collecting clamp, this thread will be released.
    5. 7
    Tap the or Cortar a la derecha button.
  5. The thread is cut off.