Clamping

Utilizza pinzatura (nell'intero progetto)

• If while generating a pattern a machine with a comb is selected and the check box Pettine is activated in the process, then the check box Utilizza pinzatura (nell'intero progetto) is already activated, but is not available.
• If when generating a new pattern the Pettine check box was deactivated, then the Utilizza pinzatura (nell'intero progetto) check box is available.
  As a result, it is possible to work without a comb but with clamping.
• This setting applies to all patterns in the project.
  All knitting programs in the knitting order for the machine need the same yarn carrier home position.

Disattiva pinzatura dopo immagliatura dei guidafili

Only available if Utilizza pinzatura (nell'intero progetto) is activated.

All yarn carriers will be taken out of the clamp at the start. Clamping and cutting will be disabled and the yarn carriers will be positioned on the clamping/cutting bed.
The total width of the needle bed can be used for knitting.

Pinzatura alla fine del tessuto nella funzione di scarico (RS17=0)

Only available if Utilizza pinzatura (nell'intero progetto) is activated.

• Clamping occurs in the cast-off function.
  With it the comb and the casting-off can be switched off by RS17=1.
• The following pieces will be knit without comb take-down.
• RS17=0 will automatically be set for the last piece in order to get the yarns clamped and the fabric cast-off.
  The setting Istruzione Sintral/PRINT appears for selection.

Istruzione Sintral/PRINT

Only available if Pinzatura alla fine del tessuto nella funzione di scarico (RS17=0) is activated.

Select a Sintral Instruction / PRINT.
The selection will be applied to the last pattern row.