Group 3 : Knitting-out

Örgüden çıkış yönü
Select the direction for knitting-out of the yarn carrier at the end of a color area

Örgüden çıkış için modül
Select a module for the knitting-out.
The module for knitting-out has two functions:
Repeatable knitting mode for feeding-out the yarn carrier and knitting mode for knot or binding at the edge of the color area.

By drag-and-drop is possible.

Open the selected module via the context menu.

Örgüden çıkış için tekrar genişliği
Select the module width for the knitting mode for feeding-out the yarn carrier.
The module width is repeatable.

İlmek kapama için sıra kaydırma
Column appears automatically if a module for knitting-out with casting-off is used

Örgüden çıkış için Sıra Ofseti
Specify the offset for the knitting-out of the yarn carrier after the end of the color area.
Related to:

• Desen sıraları
• Teknik sırası
• Ekstra sırada

Sonda düğüm / bağlama
Select the module for knot / binding at end of a color area without knitting-out.
Entry in Intarsia color areas, that do not have an assigned knitting-out module. Thus, no knitting-out will be entered.
Example: Two overlapping color areas without knitting-out and knitting-in.

By drag-and-drop is possible.

Open the selected module via the context menu.

Düğümlü örgüden çıkış için Sütun-Ofseti
Move the position of a knot (module) by x columns to the left or right.
This column is displayed automatically if a module is allocated in the Sonda düğüm / bağlama column.