Yarn Length Control

The most important changes:

• Designations were changed into Yarn length control or YLCYLCYarn Length Control (Yarn Length Control).
  The commands for the knitting program have not been changed.
• Finer control of the yarn length
  The control takes into account the finer grading of the NP values (0.05).
• Save YLC5 data (Masterpiece) as file
  The correction values of the original piece can be saved (<file name>.stx).
• If the pattern is to be knitted once again on the same machine later on.
• If the pattern is to be knitted on another machine with the same gauge.
• Sequence knitting and YLC5
  Each sequence element can be controlled with the YLC5 mode.
• The minimum fabric width is reduced from 10 to 7 inches with YLC1, YLC7 and YLC8.
• Display the yarn consumption of the produced pieces (a maximum of 10 pieces).
• New YLC8 mode
• YLC8 :
  A separate correction value is determined for each yarn carrier, depending on the knitting system in which it works.
• YLC1 :
  A separate correction value is determined for each yarn carrier, regardless in which knitting system it works.
• New device for the yarn length control
  The left and right ASCON device can be used independently of each other.