Adjusting Stitch Cams CMS OKC with Setup2
Adjust stitch cams:
Service job
Basic settings of the CMS will be overwritten!
To be done by experienced service technicians only.
Save all machine data (dongle) on the USB-Memory-Stick
- Device for the yarn length control is mounted on the CMS.
- Suitable yarns according to the yarn list are at hand.
- The operating system with Setup2 is installed.
- 1
- Define the yarn carrier type by RS18 in the Setup2 file.
- I 8= Adjustment Yarn (RS18=8)
- I 7= Adjustment Yarn (RS18=7)
- I 6= Adjustment Yarn (RS18=6)
- I 5= Adjustment Yarn (RS18=5)
- I 4= Adjustment Yarn (RS18=4)
- I 3= Adjustment Yarn (RS18=3)
- I 2= Adjustment Yarn (RS18=2)
- I 1= Adjustment Yarn (RS18=1)
- 2
- Thread up the yarn carriers in use.
- 3
- Lead the thread over the allocated measuring wheel.
- 4
- Adjust the yarn tension to 8 cN at the minimum.
- 5
- Select the adjusting program (ylc2_npk-Adjustment.zip) according to the machine type.
- 6
- Load the adjustment program.
- 7
- Watch-out the fabric width with machines without comb.
Set counters if necessary in order to get the matching fabric width for adjusting. - 8
- Set the cycle counter in Setup2 if necessary:
-
RS1 controls the length before the measuring starts
(Example: if you want to knit into the main take-down)
DefaultRS1=5 -
RS16 controls the fabric width for adjusting.
Default: RS16=0 equals half the width of the needle bed.
RS16=1 equals 2/3 of the width of the needle bed
RS16=2 equals the hole width of the needle bed. - RS19 controls the system functions
- RS19=0 Stitch formation only
- RS19=1 Stitch formation and split curve
-
RS2=999 controls the adjusting and must not be changed.
(therefore not part of Setup2)
- 9
- Start the program.
- 10
- The machine stops and prompt appears:
\!! NPK DATA WILL BE DELETED !! -- ?? COPY DONGLE ??\ - 11
- Go ahead if you have ensured, that the formerNPK data of the machine (Dongle/MC-Data) are saved or written down.