Move docking modules

Move the docking module horizontally:

    1
    Insert a docking module on the left shape edge of the pattern.
    The docking module will be inserted from the left border of the shape edge to the right.
    It is the same at the right-hand side but mirrored.
    2
    Call up the Technique tab of the Properties of:<Modul-Name> dialog box for the module with limit conditions.
    3
    Enter an offset value in the Value 1 input field of the General module attributes section.
    A positive value offsets the insertion point to the right, and a negative value to the left. The value must be entered under the properties.
  1. E.g. at the left sleeve the docking module will not be inserted at the shape edge but offset to the left by 4 needles. At the right sleeve the docking module will be inserted offset by 4 needles to the left.