Shapewizard: Load Shape Elements
Load shape elements in the Shapewizard:
Combine the shapes front, back, sleeve and collar in the Shapewizard into a Raglan with neck gore.kaw shape.
- 1
- Run the Shapewizard via the / .
- 2
- Load a shape for the element with the
button.
- The Open dialog box appears in order to select a shape file.
- 3
- Select shape.
- The shape will be loaded and the name will be displayed under .
You can remove the shape for sleeve and collar with the 
button again.
You can call-up the shape editor in order to correct the loaded shape with the 
button.
Load the shape elements for Body back, Sleeve and Collar using the same procedure.
- 4
- Specify the knitting mode for the front / back of the collar in the selection menu.
For the collar element pay attention to:
- The collar width should match the module width used.
- The collar width is dependent on the docking points.
- This means that the end width of the sleeve and body must be matched to the module width used.
- 5
- Specify stitch cross-over (connection of body and sleeve).
|
Setting |
Use |
|---|---|
|
B1-Type 1 |
Continous stitch rows in the front, i.e. no opening. |
|
B1-Type 1 TC-T |
Knitting cycle for patterns of the CMS machine with additional beds. |
|
B8 Connection of trousers |
|
|
B5 Type 1 with gore (L0) no connection L0-L1 |
Knitting cycle for pullover with Fair Isle and gore below the sleeve-body connection |
|
B6 Type 1 with gore (L0+L1) no connection L0-L1 |
Knitting cycle for pullover with Fair Isle and gore below the sleeve-body connection |
|
B2 Type 1 with opening (L0) no connection L0-L1 |
|
|
B2-Type 1 TC-T with opening (L0) |
|
|
B7 Type 1 with opening (L0) no connection L0-L1 Rib |
|
|
B3-Type1 with gore and opening (L0) and gore and opening (L1) no connection L0-L1 |
Knitting cycle for cardigan |
|
B4 Type 1 with gore and opening (L0) no connection L0-L1 |
Knitting cycle for cardigan |
|
I17-Type 1 no connection L0-L1 +I L0 Body |
Knitting cycle for intarsia on L0 |