Create a pattern with multi gauge modules

I. Preparations for generating patterns:

    1
    Open the required module group MG Binding elements of the Module Explorer of Database under Stoll / multi gauge coarse and make it available.
    - or -
    Move the module group MG Binding elements to Favorites (tab of theModules toolbar).

II. Make pattern and machine related settings:

The transition from the coarse to the fine knitting area at the motif end can be carried out in different ways.

    1
    Make the desired setting in Configuration dialog box under the Intarsia / multi gauge transitions coarse / fine tab:

III. Create pattern:

    1
    Draw a multi gauge motif with the modules of the module group multi gauge coarse.

Module

Module for the right edge


MG_Stitch v Compound

mg_Edge_Stitch v is contained in this combination module.


MG_Stitch v with transfer


MG_Edge stitch v

    2
    Switch-over to multi gauge to select the yarn colors in the Pattern Colors toolbar.
    3
    Select yarn colors with the marking .
    4
    Create the motif with the drawing tool and the MG_Stitch v Compound module.
    5
    When using the drawing tool and the MG_Stitch v with transfer module, draw in MG_selvedge stitch v at the right motif edge.

With the Multi-Gauge knitting technique, a stitch ratio between coarse and fine of 1:2 stitches results.

If several coarse areas are positioned neighboring, it is recommended to place the MG modules at the same height for production reasons.